Notes

Recommended Processing Temperature: 180 – 230oC Packaging Information: This material is packed and available in raffia bags with net content of 25.0 Kg only. The raffia bags used conforms to the minimum strength requirements of BIS, however, customer shall take due care while handling the bag. Prolonged exposure of these bags to sunlight may deteriorate the bag’s performance and cause spillage and wastage. IOCL does not warranty loss of material due to poor material handling practices. Storage & Handling: Prevent LLDPE Material from direct exposure to sunlight & heat to avoid quality deterioration. The storage location should be dry, dust free and the storage temperature should not exceed 50˚C. Non - compliance to these precautionary measures can lead to degradation of the product causing color changes, odor and inadequate product performance. Regulatory Information: LLDPE 010L22S meet “Specification for Polyethylene for safe use in contact with Foodstuff, Pharmaceuticals and Drinking water” as per IS: 10146-1982. It also confirms to the positive list of constituents as per IS: 10141-1982. The grade and Additives incorporated shall meet with FDA: CFR Title21, 177.1520, Olefin Polymers. Disclaimer: IOCL assumes no liability whatsoever in respect of application, processing or any use made of the aforementioned information or products, or any consequence thereof. No liability whatsoever shall attached to any of the IOCL companies for any infringement of the rights owned or controlled by a third party in intellectual, industrial or other property by reason of application, processing or use of the afore-mentioned information or products by the user.

Disclaimer

The information presented here was acquired by Instamine from the producer of the product or material or original information provider or from the distributor or from the producer’s website or from the open-source. However, Instamine assumes no responsibility or liability for the accuracy of the information contained on this website and strongly encourages that upon final product or material selection information is validated with the manufacturer. This website provides links to other websites owned by third parties. The content of such third-party sites is not within our control, and we cannot and will not take responsibility for the information or content.

Added to Instamine: 11-May-2022 11:00:33

Last Update: 17-May-2023 16:48:42