Notes

APPLICATIONS: Co-extruded films for lamination may be used alone or as blending component in Foam extrusion. Typical Process Conditions for Foam Extrusion: • Heating Zones (°C): 150 – 200 • Cooling Zone (°C): 80 - 100  Typical Process Conditions for Film Extrusion: • Typical Process Temp (˚C) - 160 – 200 • Recommended Blow Up Ratio (BUR): 2.0 – 3.0  Regulatory Information: • Meets the requirements stipulated in standard IS: I0146 on "Specification for Polyethylene for safe use in contact with foodstuffs, pharmaceuticals, and drinking water". It also conforms to IS 16738:2018 “Positive List of Constituents for Polypropylene, Polyethylene and their Copolymers for its Safe Use in Contact with Foodstuffs and Pharmaceuticals” • The grade and the additives incorporated in it also comply with the FDA: CFR Title 21,177.1520, Olefin polymers.  Storage Recommendations: • Bags should be stored in dry/closed conditions at temperatures below 50°C and protected from UV / direct sunlight. 

Disclaimer

The information presented here was acquired by Instamine from the producer of the product or material or original information provider or from the distributor or from the producer’s website or from the open-source. However, Instamine assumes no responsibility or liability for the accuracy of the information contained on this website and strongly encourages that upon final product or material selection information is validated with the manufacturer. This website provides links to other websites owned by third parties. The content of such third-party sites is not within our control, and we cannot and will not take responsibility for the information or content.

Added to Instamine: 05-Mar-2021 09:23:39

Last Update: 05-May-2023 11:36:56