Notes

PROCESSING CONDITIONS The PET (BC210) has to be dried to moisture content below about 30-40 ppm. The drying conditions typically used are 180 ºC for 5 hours; the dew point of the drying air should be at least -40 ºC. Typically, injection temperatures of 285 ºC maybe used to get clear preforms with acceptable acetaldehyde level for Colas and flavored drinks. FOOD REGULATION BC210 is suitable for food contact application. Detail information provided in relevant Material Safety Datasheet and for additional specific information please contact SABIC local representative for certificate.  STORAGE AND HANDLING PET resin should be stored in a manner to prevent a direct exposure to sunlight and/or heat. The storage area should also be dry with relative humidity below 50% and temperatures preferably do not exceed 50 ºC. SABIC would not give warranty to bad storage conditions, which may lead to quality deterioration such as color change, bad smell and inadequate product performance. It is advisable to process PET within 6 months after delivery. 

Disclaimer

The information presented here was acquired by Instamine from the producer of the product or material or original information provider or from the distributor or from the producer’s website or from the open-source. However, Instamine assumes no responsibility or liability for the accuracy of the information contained on this website and strongly encourages that upon final product or material selection information is validated with the manufacturer. This website provides links to other websites owned by third parties. The content of such third-party sites is not within our control, and we cannot and will not take responsibility for the information or content.

Added to Instamine: 02-Mar-2021 10:40:35

Last Update: 02-Mar-2021 16:22:21