Notes

Typical Processing Conditions: Extrusion Temperature: 220 – 260 °C Quenching Temperature: 10 – 25 °C Draw Ratio: 1.2 – 1.6 Note: Processing parameters mentioned above are for reference only and not to be considered as specifications. They may vary based on the product to be manufactured. Applications: Staple fibers for thermal bonded and needle punched nonwovens, High tenacity filament yarns.  Regulatory Information: The product complies with Indian Standard IS 10910 on “Specification for polypropylene and its copolymers for safe use in contact with foodstuffs, pharmaceuticals and drinking water. It also conforms to IS 16738:2018 on positive list of constituents for polypropylene, polyethylene and their copolymers for its safe use in contact with foodstuffs and pharmaceuticals. The grade and the additives incorporated in it also comply with the FDA: CFR Title 21,177.1520, Olefin polymers. Storage Recommendations: Bags should be stored in dry/closed conditions at temperatures below 50°C and protected from UV / direct sunlight.

Disclaimer

The information presented here was acquired by Instamine from the producer of the product or material or original information provider or from the distributor or from the producer’s website or from the open-source. However, Instamine assumes no responsibility or liability for the accuracy of the information contained on this website and strongly encourages that upon final product or material selection information is validated with the manufacturer. This website provides links to other websites owned by third parties. The content of such third-party sites is not within our control, and we cannot and will not take responsibility for the information or content.

Added to Instamine: 10-Mar-2021 09:58:56

Last Update: 09-Jun-2023 16:19:11